ZyXEL Communications OLT2406 - UNI Port CFM MEP Settings

OLT2406 User’s Guide
687
This example shows the MAC limit setting on uniport-1-1 of ONT-5-1-3.
96.4.8 UNI Port CFM MEP Settings
Use the cfm-mep command to configure a maintenance association end point on a UNI port.
OLT2406 # show remote uniport uniport-5-1-3-1-1 mac-limit
Mac Limit Active : YES
Mac Limit Number : 128
Table 363 UNI Port CFM MEP Commands
LABEL DESCRIPTION M P
remote uniport <aid>
Configures UNI port settings.
aid: uniport-<slot>-<pon>-<ont>-<card>-
<port>
C13
cfm-mep <1-8191> ma-index <ma-
index> priority <0-7>
Configures IEEE 802.1ag CFM MEP for remote UNI
port.
mep-index: MEP’s own identity in the MA. For a
given MA, each MEP ID must be unique
throughout the network defined by the MD. The
MEP ID is defined in the range 1-8191.
ma-index: Maintenance association index with
which the MEP is associated.
priority: CCM and CTM frames are
transmitted according to this specified IEEE
802.1p priority. The priority is also used in LTR
frames originating from this MEP.
C13
cfm-mep help
Describes the cfm mep command. C 13
no cfm-mep <cr>
Deletes the UNI port’s CFM MEP configuration. C 13
show remote uniport <aid> cfm-mep
<cr>
Displays the specified UNI port’s CFM MEP
configuration.
aid: uniport-<slot>-<pon>-<ont>-<card>-
<port>
E13