Chapter 29 PPPoE
OLT2406 User’s Guide
261
29.3.4 PPPoE IA for VLAN
Use this screen to set whether the PPPoE Intermediate Agent is enabled on a VLAN and whether the OLT
appends the Circuit ID and/or Remote ID to PPPoE discovery packets from a specific VLAN. See Section
29.3.3 on page 259 for the priority of Circuit and Remote ID information that will be used in this screen.
Click the VLAN link in the Intermediate Agent screen to display the screen as shown.
Figure 158 Advanced Application > PPPoE > Intermediate Agent > VLAN
The following table describes the labels in this screen.
ONT ID This is the identifier of an ONT.
Note: When register method D or E is selected and activated in the Advanced
Application > OLT Registration screen, ONT ID 121-128 are the ONT template IDs.
pass through Select this to forward packets with PPPoE options from an ONT. Otherwise, they’ll be dropped.
Note: When ONT ID 121-128 are the ONT template IDs, the setting for this field applies
to the Advanced Application > ONT Template screen.
disable Deselect this to add PPPoE options in outgoing packets. You can set up PPPoE options in the
Advanced Application > PPPoE > Intermediate Agent screen.
Note: When ONT ID 121-128 are the ONT template IDs, the setting for this field applies
to the Advanced Application > ONT Template screen.
Apply Click Apply to save your changes to the OLT’s run-time memory. The OLT loses these changes if it
is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Paging
Prev/Next Click Prev or Next to show the previous/next screen if all status information cannot be seen in
one screen.
Table 105 Advanced Application > PPPoE > Intermediate Agent > Port > ONT Option
LABEL DESCRIPTION
Table 106 Advanced Application > PPPoE > Intermediate Agent > VLAN
LABEL DESCRIPTION
Show VLAN Use this section to specify the VLANs you want to configure in the section below.
Start VID Enter the lowest VLAN ID you want to configure in the section below.
End VID Enter the highest VLAN ID you want to configure in the section below.
To Next Page
Loading...
