Chapter 37 OLT Registration
OLT2406 User’s Guide
298
37.3 The Tca Configuration Screen
Use this screen to configure thresholds for the (Threshold-Crossing Alarms) TCA profile. Click Tca
Configuration in the Advanced Application > OLT Registration screen to display the screen as shown.
The OLT will send threshold-crossing alarms to an ONT if the ONT’s parameters go beyond the thresholds
configured here.
Figure 181 Advanced Application > OLT Registration > Tca Configuration
The following table describes the labels in this screen.
Delete Click Delete to remove the profiles with the Delete option selected.
Cancel Click Cancel to begin configuring the screen again.
Table 127 Advanced Application > OLT Registration
LABEL DESCRIPTION
Table 128 Advanced Application > OLT Registration > Tca Configuration
LABEL DESCRIPTION
Tca Active Select this to enable low rate Threshold Crossing Alert (TCA) alarm.
AID Enter the identifier for the ONT that you want the settings configured here to apply to.
FEC
Corrected
Byte
Threshold
Enter the threshold of corrected bytes that can be received in the Forward Error Correction (FEC)
process.
FEC
Corrected
Code Word
Threshold
Enter the threshold of corrected codewords that can be received in the Forward Error Correction
(FEC) process.
FEC
Uncorrected
Code Word
Threshold
Enter the threshold of codewords that can be received without being corrected in the Forward
Error Correction (FEC) process.
BIP byte
Threshold
Enter the threshold of Bit Interleaved Parity (BIP) bytes that can be received.
BIP error
Threshold
Enter the threshold of Bit Interleaved Parity (BIP) errors that are allowed.
To Next Page
Loading...
