Chapter 36 QoS Profile
OLT2406 User’s Guide
292
The following table describes the labels in this screen.
36.4 ONT QoS Pbit Profile
Use this screen to configure ONT QoS profiles that translate IEEE 802.1p priority bit values to other values.
Click Pbit-Profile in the Advanced Application > QoS Profile screen to display the screen as shown.
Table 124 Advanced Application > QoS Profile > Bw-Profile
LABEL DESCRIPTION
Name Specify a name for the bandwidth profile.
Ustype Specify the upstream bandwidth group type the profile uses.
The upstream bandwidth group type and profile settings display below this field. Click Type Help to
display all bandwidth group types and how their bandwidth is controlled by SIR, AIR, and PIR
parameters respectively.
Figure 177 ONT Templates
SIR Specify the profile’s Sustained Information Rate (SIR) in kbps.
AIR Specify the profile’s Access Information Rate (AIR) in kbps.
PIR Specify the profile’s Peak Information Rate (PIR) in kbps.
The PIR is the maximum bandwidth allowed for the incoming traffic flow on a port when there is no
network congestion.
Apply Click Apply to save the changes.
Cancel Click Cancel to clear the fields.
Clear Click Clear to return the screen’s settings to the defaults.
Index This is the index number of an ONT QoS bandwidth profile.
Name This is the name of the profile.
Ustype This displays the upstream bandwidth group type the profile uses.
Rule This displays the profile’s settings.
Delete Select this for one or more profiles and click Delete to remove them.
* Use this row to select all of the profiles for deletion.
Delete Click Delete to remove the profiles with the Delete option selected.
Cancel Click Cancel to begin configuring the screen again.
Paging
Prev/Next Click Prev or Next to show the previous/next screen if all status information cannot be seen in one
screen.
To Next Page
Loading...
