Chapter 18 Link Aggregation
OLT2406 User’s Guide
157
18.3 Link Aggregation Setting
Click Advanced Application > Link Aggregation > Link Aggregation Setting to display the screen shown
next. See Section 18.1 on page 155 for more information on link aggregation.
Figure 98 Advanced Application > Link Aggregation > Link Aggregation Setting
Aggregator ID Link Aggregator ID consists of the following: system priority, MAC address, key, port priority and
port number. Refer to Link Aggregation ID on page 156 for more information on this field.
The ID displays only when there is a port belonging to this trunk group and LACP is also enabled
for this group.
Criteria This shows the outgoing traffic distribution algorithm used in this trunk group. Packets from the
same source and/or to the same destination are sent over the same link within the trunk.
src-mac means the OLT distributes traffic based on the packet’s source MAC address.
dst-mac means the OLT distributes traffic based on the packet’s destination MAC address.
src-dst-mac means the OLT distributes traffic based on a combination of the packet’s source
and destination MAC addresses.
src-ip means the OLT distributes traffic based on the packet’s source IP address.
dst-ip means the OLT distributes traffic based on the packet’s destination IP address.
src-dst-ip means the OLT distributes traffic based on a combination of the packet’s source and
destination IP addresses.
Status This field displays how these ports were added to the trunk group. It displays:
• Static - if the ports are configured as static members of a trunk group.
• LACP - if the ports are configured to join a trunk group via LACP.
Table 50 Advanced Application > Link Aggregation
LABEL DESCRIPTION
To Next Page
Loading...
