OLT2406 User’s Guide
684
96.4.6 UNI Port IGMP Channel Settings
Use the igmpchannel command to configure a UNI port with multicast subscriber information.
Table 359 UNI Port IGMP Channel Commands
LABEL DESCRIPTION M P
remote uniport <aid>
Configures UNI port settings.
aid: uniport-<slot>-<pon>-<ont>-<card>-
<port>
C13
igmpchannel <uni-vid>
[version <IGMPv2|IGMPv3>]
[cacprof <prof>] [maxgroup
<num>] [maxmsg <num>]
[signaling <on|off>]
[previewpkg <packages>]
[fullviewpkg <packages>]
[txtag
<transparent|untag|replace
<1~4094>>] [active <on|off>]
Configures a UNI port IGMP channel.
uni-vid: The default VLAN ID for IGMP reports,
that is Join and Leave packets. You must first
create the VLAN using the vlan command
under the remote uniport command.
(Required.)
version: Configures the IGMP version to either
IGMPv2 or IGMPv3. (Optional, default IGMPv2.)
cacprof: Adapts a QoS CAC profile which
contains multicast bandwidth settings and is
created by the qos cacprof command.
(Optional.)
maxgroup: <0-512>. The maximum number of
multicast groups a client can join concurrently.
(Optional, default 64.)
maxmsg: <0-255>. The maximum number of IGMP
reports a client can send per second. (Optional,
default 0.)
signaling: <on|off>. Enables the IGMP
signaling mode. That is, it lets the OLT control
and decide the multicast table of the ONT. The
ONT must also support this feature. (Optional,
default off.)
previewpkg: Configures a list of package
members with preview privilege. That is, IGMP
clients can join groups in these package
members only in a period of time. Use the
mcast-channel command to create the
package members. The ONT must also support
this feature. (Optional.)
fullviewpkg: Configures a list of package
members with full view privilege. That is, IGMP
clients can join to groups in these package
members all the time. Use the mcast-channel
command to create the package members.
(Optional.)
txtag: Sets whether the ONT sends multicast
downstream traffic with a VLAN behavior. Use
transparent if you want to follow the uniport
VLAN txtag setting. Use
untag for untagged
VLAN. Use
replace to replace the original
VLAN with a specific VID.
active: Activates/deactivates this CLI
configuration and, for the remote ONT UNI port,
provisions OMCI to ONT. (Optional, default is on.)
C13
no igmpchannel <cr>
Deletes the UNI port IGMP channel. C 13
To Next Page
Loading...
