ZyXEL Communications OLT2406 - Access Control; Access Control Overview; Chapter 44 Access Control; The Access Control Main Screen

OLT2406 User’s Guide
354
CHAPTER 44
Access Control
44.1 Access Control Overview
This chapter describes how to control access to the OLT.
FTP is allowed one session. Telnet and SSH share five sessions. Up to five Web sessions (five different user
names and passwords) and/or limitless SNMP access control sessions are allowed.
44.1.1 What You Can Do
• Use the Access Control screen (Section 44.2 on page 354) to display the main screen.
• Use the SNMP screen (Section 44.3 on page 355) to configure your SNMP settings.
• Use the Trap Group screen (Section 44.3.1 on page 356) to specify the types of SNMP traps that should
be sent to each SNMP manager.
• Use the User Information screen (Section 44.3.2 on page 357) to create SNMP users for authentication
with managers using SNMP v3 and associate them to SNMP groups.
• Use the Logins screens (Section 44.4 on page 358) to assign which users can access the OLT via web
configurator at any one time.
• Use the Service Access Control screen (Section 44.5 on page 360) to decide what services you may
use to access the OLT.
• Use the Remote Management screen (Section 44.6 on page 361) to specify a group of one or more
“trusted computers” from which an administrator may use a service to manage the OLT.
44.2 The Access Control Main Screen
Use this screen to display the main screen.
Click Management > Access Control in the navigation panel to display the main screen as shown.
Figure 218 Management > Access Control
Table 166 Access Control Overview
SSH Telnet FTP Web SNMP
Share up to nine sessions One session Up to five accounts No limit