ZyXEL Communications OLT2406 - Link Aggregation Commands; Link Aggregation ID

OLT2406 User’s Guide
490
Configure trunk groups or LACP before you connect the Ethernet switch to avoid causing network
topology loops.
68.2.1 Link Aggregation ID
LACP aggregation ID consists of the following information
3
:
68.3 Link Aggregation Commands
The following table describes the related commands.
Table 246 Link Aggregation ID: Local Switch
SYSTEM PRIORITY MAC ADDRESS KEY PORT PRIORITY PORT NUMBER
0000 00-00-00-00-00-00 0000 00 0000
Table 247 Link Aggregation ID: Peer Switch
SYSTEM PRIORITY MAC ADDRESS KEY PORT PRIORITY PORT NUMBER
0000 00-00-00-00-00-00 0000 00 0000
3. Port Priority and Port Number are 0 as it is the aggregator ID for the trunk group, not the individual port.
Table 248 Trunk Commands
COMMAND DESCRIPTION M P
show trunk
Displays link aggregation information. E 3
trunk <T1|T2>
Activates a trunk group. C 13
no trunk <T1|T2>
Disables the specified trunk group. C 13
trunk <T1|T2> criteria <src-
mac|dst-mac|src-dst-mac|src-
ip|dst-ip|src-dst-ip>
Sets the traffic distribution type used for the
specified trunk group.
C13
no trunk <T1|T2> criteria
Returns the traffic distribution type used for the
specified trunk group to the default (src-dst-
mac).
C13
trunk <T1|T2> interface <aid>
Adds a port(s) to the specified trunk group.
aid: slot-<slot> | msc-<slot>-<port>
C13
no trunk <T1|T2> interface <aid>
Removes ports from the specified trunk group. C 13
trunk <T1|T2> lacp
Enables LACP for a trunk group. C 13
no trunk <T1|T2> lacp
Disables LACP in the specified trunk group. C 13
trunk interface <aid> timeout
<lacp-timeout>
Defines LACP timeout period (in seconds) for the
specified port(s).
lacp-timeout: 1 or 30
C13
Table 249 LACP Commands
COMMAND DESCRIPTION M P
show lacp
Displays LACP (Link Aggregation Control
Protocol) settings.
E3
lacp
Enables Link Aggregation Control Protocol
(LACP).
C13