ZyXEL Communications OLT2406 - UNI Port Protocol-Based VLAN Settings

Chapter 96 Remote ONT
OLT2406 User’s Guide
681
96.4.4 UNI Port Protocol-based VLAN Settings
Use the protocol-based command to configure UNI port protocol-based VLAN.
This example creates 3 protocol-based VLAN rules on ONT-5-1-3 uniport-1-1 to have the ONT do the
following:
• Insert vlan103 and pbit 4 in IPoE packets the ONT forwards to the OLT.
• Insert vlan103 and pbit 4 in ARP packets the ONT forwards to the OLT.
• Insert vlan203 and pbit 0 in PPPoE packets the ONT forwards to the OLT.
Table 357 UNI Port Protocol-based VLAN Command Parameters
LABEL DESCRIPTION M P
remote uniport <aid>
Configures UNI port settings.
aid: uniport-<slot>-<pon>-<ont>-<card>-
<port>
C13
protocol-based
<ipoe|pppoe|arp|ipv6> [vlan
<VID|SVID:CVID>] [def-pbit
<priority>] [active <on | off>]
Configures protocol-based VLAN flow settings
for the UNI port.
ipoe|pppoe|arp|ipv6:
IPoE packet ethertype = 0x0800
PPPoE packet ethertype = 0x8863 , 0x8864
ARP packet ethertype = 0x0806
IPv6 packet ethertype = 0x86DD
vlan: The VLAN the ONT inserts in the protocol
packet.
def-pbit: The priority bit the ONT inserts in the
protocol packet.
active: Enable or diable the protocol packet
rule.
C13
no protocol-based
<ipoe|pppoe|arp|ipv6>
Deletes the protocol-based vlan flow.
ipoe|pppoe|arp|ipv6:
IPoE packet ethertype = 0x0800
PPPoE packet ethertype = 0x8863 , 0x8864
ARP packet ethertype = 0x0806
IPv6 paceket ethertype = 0x86DD
C13
no protocol-based <cr>
Deletes all of the UNI port’s protocol-based
VLAN flow settings.
C13
show remote uniport <aid> protocol-
based <cr>
Displays the specified UNI port’s protocol-based
VLAN flow settings.
aid: uniport-<slot>-<pon>-<ont>-<card>-
<port>
E13
OLT2406 (config)# remote uniport uniport-5-1-3-1-1
OLT2406 (config-remote-uniport)# protocol-based ipoe vlan 103 pbit 4
OLT2406 (config-remote-uniport)# protocol-based pppoe vlan 203 pbit 0
OLT2406 (config-remote-uniport)# protocol-based arp vlan 103 pbit 4