ZyXEL Communications OLT2406 - Page 304

Chapter 38 ONT Template
OLT2406 User’s Guide
304
Storm
Threshold
Enter a value in the range of 1 to 65535 and set the maximum rate in packets per second (pps)
that packets are allowed to arrive at the remote ONT.
Plan Version Enter the ONT planned version of up to 14 characters to upgrade the ONT’s firmware via OMCI.
The planned version is the firmware ID of the firmware that you want the ONT to use.
Option 82
See Table 104 on page 259
and Table 160 on page 343 for more information about DHCP/PPPoE options and
DHCP/PPPoE passthrough.
Circuit ID Enter a string of up to 63 ASCII characters that the OLT adds into the Circuit ID sub-option. Spaces
are allowed.
Remote ID Enter a string of up to 63 ASCII characters that the OLT adds into the Remote ID sub-option.
Spaces are allowed.
Disable Deselect DHCP to add DHCP options in outgoing packets. You can set up DHCP options in the
Circuit ID and Remote ID fields.
Deselect PPPoE to add PPPoE options in outgoing packets. You can set up DHCP options in the
Circuit ID and Remote ID fields.
Pass Through Select DHCP to forward packets with DHCP options from an ONT. Otherwise, they’ll be dropped.
Select PPPoE to forward packets with PPPoE options from an ONT. Otherwise, they’ll be dropped.
UNI Port
CardID 1
10_100_1000B
ASET
Select this to have the Ethernet ports on an ONT, to use 10 Mbps, 100 Mbps, or 1000 Mbps.
CardID 2 VEIP Select this to use a virtual Ethernet card on a router mode ONT.
CardID 3 POTS Select this to use a virtual VoIP card on an ONT.
CardID 4
VIDEO
Select this to use a virtual video card on an ONT.
CardID 5
10_100BASET
Select this to have the Ethernet ports on an ONT to use 10 Mbps or 100 Mbps.
CardID 6
10_100_1000B
ASET_VEIP
Select this to have the Ethernet ports on an ONT to use 10 Mbps, 100 Mbps, or 1000 Mbps, and use
a virtual Ethernet card on a router mode ONT.
Uniport List Enter the numbers of the ports on the ONT.
Speed Select the auto detection configuration attribute in the physical path termination point. Use auto
or a specific rate and duplex mode.
PMenable Select DISABLE to disable pm (performance monitoring) on the virtual card type.
Select 64-bit to enable PM (performance monitoring) to get 64-bit counters on this virtual card
type by getting IP host performance monitoring history data ME as defined in G.988.
Select 32-bit to enable PM (performance monitoring) to get 32-bit counters on this virtual card
type by getting IP host performance monitoring history data ME as defined in G.984.4.
AID This is the ONT’s ID in the format: ont-<pon>-<ont>.
Active This shows whether the ONT is enabled or disabled.
Description This displays the description to aid in identifying the template.
AlarmProfile This displays the alarm profile this template uses.
FullBridge This displays Y if you have the ONT allow the traffic of all the four UNI ports once any one of them
is configured.
AntiMACSpoof This displays Y if you have anti-MAC spoofing activated for the ONT.
Table 131 Advanced Application > ONT Template
LABEL DESCRIPTION