Chapter 96 Remote ONT
OLT2406 User’s Guide
679
Before creating a VLAN rule, we need to create the tc (traffic class) that controls the VLAN’s bandwidth.
In the previous section we created tc3 and tc4 as below.
remote uniport uniport-5-1-3-1-1
queue tc 3 priority 3 weight 0 USbwprofname 20m DSBwprofname 20m dsoption olt
bwsharegroupid 1
queue tc 4 priority 4 weight 0 USbwprofname 40m DSBwprofname 40m dsoption olt
bwsharegroupid 1
To map the IEEE 802.1p priority bit
from a VLAN to a traffic class , we need to create an ingress profile to
use when we create the UNI port VLAN.
qos ingprof Pbit3ToTc3 dot1p3tc 3
qos ingprof Pbit4ToTc4 dot1p4tc 4
aesencrypt
: The UNI port VLAN to assign to
the gem port. This setting enables gem port AES
encryption.
TR156: Reserved for future development. Use
“disable” as the default.
sharepri: The share priority in a downstream
share group if the dsoption is olt. The value "off"
means discard the downstream share group
setting. If other VLANs have "0-7" set in the same
downstream share group, the value cannot be
set to "off". The priority value means the priority
of VLAN of downstream rate limit and is unique
in the same downstream bandwidth group. 7
has the highest priority.
macnum: You can set the maximum number (1-6)
of metered downstream MAC addresses per
GEM port. Excess MAC addresses can transmit
traffic without bandwidth metering.
If the share priority in a downstream share group
is not configured, there’s no limitation of
metered downstream MAC addresses per GEM
port.
active: Turn the VLAN flow setting rule on or off
on the UNI port.
C13
vlan help
Provides more information about the specified
command.
C13
no vlan <uni-vid>
Deletes the VLAN flow settings from the UNI port. C 13
no vlan all
Deletes all of the UNI port’s VLAN flow settings. C 13
show remote uniport <aid> vlan
<uni-vid>
Displays the specified UNI port’s VLAN flow
settings for the specified VLAN.
aid: uniport-<slot>-<pon>-<ont>-<card>-
<port>
E13
show remote uniport <aid> vlan <cr>
Displays all of the specified UNI port’s VLAN flow
settings.
aid: uniport-<slot>-<pon>-<ont>-<card>-
<port>
E13
Table 356 UNI Port VLAN Command Parameters (continued)
LABEL DESCRIPTION M P
To Next Page
Loading...
