Chapter 78 VoIP
OLT2406 User’s Guide
564
2nd-packet-period <10-30>
Specifies the second packet period selection
interval (In milliseconds). This value is useful when
the media gateway controller does not provide
the preferred compression algorithm and
packet period parameter to the ONT. The range
depends on the type of codec selected.
C13
2nd-silence <enable|disable>
Turns the use of silence suppression with the
second codec on or off.
C13
3rd-codec <encoding name>
Specifies the third audio codec to tell the
remote ONT. The remote ONT must use the same
codec as the peer. The options are the same as
described for the first codec.
C13
3rd-packet-period <10-30>
Specifies the third packet period selection
interval (In milliseconds). This value is useful when
the media gateway controller does not provide
the preferred compression algorithm and
packet period parameter to the ONT. The range
depends on the type of codec selected.
C13
3rd-silence <enable|disable>
Turns the use of silence suppression with the third
codec on or off.
C13
4th-codec <encoding name>
Specifies the fourth audio codec to tell the
remote ONT. The remote ONT must use the same
codec as the peer. The options are the same as
described for the first codec.
C13
4th-packet-period <10-30>
Specifies the fourth packet period selection
interval (In milliseconds). This value is useful when
the media gateway controller does not provide
the preferred compression algorithm and
packet period parameter to the ONT. The range
depends on the type of codec selected.
C13
4th-silence <enable|disable>
Turns the use of silence suppression with the
fourth codec on or off.
C13
announce-type <silence|reo-
ton|fas-bus|voi-ann>
Sets the treatment for when a subscriber goes
off-hook. Here are the options and what they
represent.
silence: Silence
reo-ton: Reorder tone
fas-ton: Fast busy
voi-ann: Voice announcement
C13
cas <enable|disable>
Enables or disables handling of DTMF via RTP cas
events as defined in RFC 4733.
C13
dscp-mark <0~63>
Specifies the Diffserv code point (From 0 to 63)
to use for outgoing RTP packets.
C13
dtmf <enable|disable>
Enables or disables handling of DTMF via RTP
DTMF events as defined in RFC 4733.
C13
echo-cancel <enable|disable>
Enables or disables echo cancellation. C 13
fax-mode <passthru|T38>
Sets how to handle faxes. Use passthru to
transmit faxes as voice (in-band). Use T38 to
transmit faxes as separate packets (out-of-
band) according to ITU-T T.38.
C13
Table 294 VoIP Common Profile Commands (continued)
COMMAND DESCRIPTION M P
To Next Page
Loading...
