Chapter 46 Syslog Setup
OLT2406 User’s Guide
383
Figure 240 Management > Syslog > Syslog Upload Setup
The following table describes the labels in this screen.
Table 183 Management > Syslog > Syslog Upload Setup
LABEL DESCRIPTION
Syslog Upload Setup
Syslog Upload Select Active to upload the file with log messages to the external syslog server configured
below.
Upload Time Enter the time that you want the OLT to upload the file with log messages.
Apply Click Apply to save your changes to the OLT’s run-time memory. The OLT loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to return the fields to the factory defaults.
Server Active Select this to activate the syslog server.
Server Address Enter the IPv4 address of the syslog server.
Username Enter the username of the syslog server.
Password Enter the password of the syslog server.
Filepath Enter the location of the syslog server that you want the file with log messages to be
uploaded to.
Add Click Add to save your changes to the OLT’s run-time memory. The OLT loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to return the fields to the factory defaults.
Index This field displays the index number.
Active This displays whether the entry of the syslog server settings is active or not.
IP Address This displays the IP address of the syslog server.
Username This displays the username of the syslog server.
Password This displays the password of the syslog server.
To Next Page
Loading...
