Chapter 9 VLAN
OLT2406 User’s Guide
119
The following table describes the related labels in this screen.
Table 29 on page 120 introduces the mappings of the port number in the following listed screens and
the physical ports:
• Advanced Application > VLAN > VLAN Status> VLAN Port Setting
• Advanced Application > VLAN > VLAN Detail
• Advanced Application > VLAN > VLAN Port Setting > Protocol Based Vlan
• Advanced Application > VLAN > VLAN Status > Static VLAN
• Advanced Application > Port Authentication > 802.1x
• Advanced Application > Port Authentication > 802.1x > Guest VLAN
Table 28 Advanced Application > VLAN > VLAN Status > Static VLAN
LABEL DESCRIPTION
ACTIVE Select this check box to activate the VLAN settings.
Name Enter a descriptive name for the VLAN group for identification purposes. This name consists of up
to 64 printable characters. Spaces are allowed.
VLAN Group ID Enter the VLAN ID for this static entry; the valid range is between 1 and 4094.
Port The port number identifies the port you are configuring.
The first 4-8 ports maps with the physical PON ports of OLT1404A and 14048A, and the rest maps
with the other physical ports on the OLT’s front panel.
See Table 29 on page 120 for more detailed information.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Control Select Normal for the port to dynamically join this VLAN group using GVRP. This is the default
selection.
Select Fixed for the port to be a permanent member of this VLAN group.
Select Forbidden if you want to prohibit the port from joining this VLAN group.
Tagging Select TX Tagging if you want the port to tag all outgoing frames transmitted with this VLAN
Group ID.
Add Click Add to save your changes to the OLT’s run-time memory. The OLT loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Cancel Click Cancel to change the fields back to their last saved values.
Clear Click Clear to start configuring the screen again.
VID This field displays the ID number of the VLAN group. Click the number to edit the VLAN settings.
Active This field indicates whether the VLAN settings are enabled (Yes) or disabled (No).
Name This field displays the descriptive name for this VLAN group.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the check boxes.
Paging
Prev/Next Click Prev or Next to show the previous/next screen if all status information cannot be seen in
one screen.
To Next Page
Loading...
