Chapter 23 Queuing Method
OLT2406 User’s Guide
190
Hybrid-SPQ
Lowest-
Queue
This field is applicable only when you select WFQ.
Select a queue (Q0 to Q7) to have the OLT use SPQ to service the subsequent queue(s) after and
including the specified queue for the port. For example, if you select Q5, the OLT services traffic on
Q5, Q6 and Q7 using SPQ.
Select None to always use WFQ for the port.
Apply Click Apply to save your changes to the OLT’s run-time memory. The OLT loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Advanced Application > Queuing Method (continued)
LABEL DESCRIPTION
To Next Page
Loading...
