ZyXEL Communications OLT2406 - Page 311

Chapter 38 ONT Template
OLT2406 User’s Guide
311
The following table describes the labels in this screen.
Table 135 Advanced Application > ONT Template > Uniport Multicast
LABEL DESCRIPTION
Choose the GPON interface that you want the settings configured here to apply to from the first
drop-down list.
Choose the template that you want the settings configured here to apply to from the second
drop-down list.
Active Select this to activate this multicast channel on the UNI port.
Uniport AID Select a UNI port on the ONT. The UNI ports are represented by the format: uniport-<pon>-<ont>-
<card>-<port>.
UNIVID Select the VLAN ID of the multicast channel.
Version Select the IGMP version for the multicast traffic transmission over this multicast channel, either
igmpv2 or igmpv3.
Cac Profile Select a QoS CAC profile which contains multicast bandwidth settings. Click CAC Profile Setting
to view the profile details.
Maxgroup Enter the maximum number of multicast groups a client can join concurrently.
Maxmsg Enter the maximum number of IGMP reports a client can send per second.
Singnaling on Select this to enable the IGMP signaling mode. It lets the OLT control and decide the multicast
table of the ONT. The ONT must also support this feature.
Previewpkg Configure a list of package members with preview privilege. That is, IGMP clients can join groups
in these package members only in a period of time.
You can enter individual packages separated by a comma or a range of packages by using a
dash.
Example:
2, 4, 6 indicates that packages 2, 4 and 6 are the package members.
2-6 indicates that packages 2 through 6 are the package members.
Use the mcast-channel command to create the package members. The ONT must also support
this feature.
Fullviewpkg Configure a list of package members with full view privilege. That is, IGMP clients can join groups
in these package members all the time. Use the mcast-channel command to create the
package members.
You can enter individual packages separated by a comma or a range of packages by using a
dash.
Example:
2, 4, 6 indicates that packages 2, 4 and 6 are the package members.
2-6 indicates that packages 2 through 6 are the package members.
Tx-tag Select untag to not tag downstream multicast traffic.
Select transparent to tag downstream multicast traffic according to the ONT VLAN TX tag setting.
Select replace to replace the original VLAN with a specific VID. Enter the VID in the field to the
right.
Add Click Add to add a UNI port multicast entry.
Cancel Click Cancel to clear the fields.
Clear Click Clear to return the screen’s settings to the defaults.
Index This is the index number of a UNI port multicast channel setting.
AID This is the UNI port’s ID in the format: uniport-<pon>-<ont>-<card>-<port>.