Chapter 38 ONT Template
OLT2406 User’s Guide
316
IP Address
/ Address
Prefix
Enter a source IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
A subnet mask can be represented in a 32-bit notation. For example, the subnet mask
“255.255.255.0” can be represented as “11111111.11111111.11111111.00000000”, and counting
up the number of ones in this case results in 24.
Socket
Number
Note: You must enter either the UDP or TCP protocol number in the IP Protocol field
before you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second option
and enter a TCP/UDP protocol port number. Refer to Section Table 140 on page 317 for more
information.
Destination
IP Address
/ Address
Prefix
Enter a destination IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
Socket
Number
Note: You must enter either the UDP or TCP protocol number in the IP Protocol field
before you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second option
and enter a TCP/UDP protocol port number. Refer to Section Table 140 on page 317 for more
information.
Add Click Add to create the entry in the summary table below and save your changes to the OLT’s
runtime memory. The OLT loses these changes if it is turned off or loses power, so use the Save link
on the top navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to clear the fields.
Clear Click Clear to return the screen’s settings to the defaults.
Index This field displays the index number of the rule.
Name This field displays the descriptive name for this ACL profile.
Active This field displays whether this ACL profile is enabled or not.
Policy This field displays the action that an ONT will take when the traffic matches the rules.
Interface This field displays the interface that the rules are applied to.
Counter This field displays whether packet counting is enabled or not for this ACL profile.
Logging This field displays whether packet logging is enabled or not for this ACL profile.
Rule This field displays a summary of this ACL profile’s settings.
Delete Select this for one or more entries and click Delete to remove them.
* Select this to select all of the entries for deletion.
Delete Click Delete to remove the entries with the Delete option selected.
Cancel Click Cancel to begin configuring the screen again.
Table 138 Advanced Application > ONT Template > ONT ACL > ACL Profile Setting
LABEL DESCRIPTION
To Next Page
Loading...
