Chapter 42 DHCP
OLT2406 User’s Guide
344
Figure 210 IP Application > DHCP > Option > ONT Option
The following table describes the labels in this screen.
Table 161 IP Application > DHCP > Option > ONT Option
LABEL DESCRIPTION
Choose the GPON interface that you want the settings configured here to apply to from the
drop-down list.
Index This is the index number of the ONT connected to the GPON interface.
ONT ID This is the identifier of an ONT.
Note: When register method D or E is selected and activated in the Advanced
Application > OLT Registration screen, ONT ID 121-128 are the ONT template
IDs.
pass through Select this to forward packets with DHCP options from an ONT. Otherwise, they’ll be dropped.
You can set up DHCP options in the IP Application > DHCP > Option screen.
Note: When ONT ID 121-128 are the ONT template IDs, the setting for this field applies
to the Advanced Application > ONT Template screen.
disable Deselect this to add DHCP options in outgoing packets. You can set up DHCP options in the IP
Application > DHCP > Option screen.
Note: When ONT ID 121-128 are the ONT template IDs, the setting for this field applies
to the Advanced Application > ONT Template screen.
Apply Click Apply to save your changes to the OLT’s run-time memory. The OLT loses these changes if
it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Paging
Prev/Next Click Prev or Next to show the previous/next screen if all status information cannot be seen in
one screen.
To Next Page
Loading...
