Chapter 78 VoIP
OLT2406 User’s Guide
573
content-table <1 ~ 4> <token>
Configures a dialing token (rule) in the dial plan
table.
Identify a dial plan table entry number (from 1 to
4) and dial plan rule (from 1 to 28 characters).
Dial plan rules: Symbols, and Descriptions:
Multiple Rule: |, Use "|" to separate multiple
rules.
Any one numeric digit: x, Allow the user to input
any numeric digit (0~9), one 'x' means one digit
A subset of keys: [], Allow the user to input a
range of digits, for example: [1-3] or [148]
Repeat: ., Allow the user to input a repeatable
digit (above o times). For example: (12.) allows
1, 12, 122, and 1222.
Append: <:123>, Append '123' digits in the place
of the rule.
Remove: <123:>, Remove '123' digits in the place
of the rule.
Replace: <123:456>, Replace '123' digits with
'456' digits in the place of the rule.
Block: !, Type '!' at the end of the rule, to block
the number which matches the rule.
Wait Timeout to Dial: T, Type 'T' at the end of the
rule, once the dialed number is input, the call is
dialed out after the timeout.
Gateway: =gw0=,=gw3=, Type one of these at
the end of the rule and when a dialed number
matches the rule, the device transfers the call to
the gateway (0: FXS port; 3: SIP).
C13
voip-service mode sip vlan <1-
4094> common-profile
<name> sip-profile <name>
[dial-plan <name>] [username
<name>] [password <password>]
Configures UNI port VoIP settings.
mode: sip mode (SIP) is supported.
vlan: Specify the VLAN ID (1 to 4094) the UNI
port should use for VoIP traffic.
common-profile: Specify the name of an
existing SIP common profile.
sip-profile: Specify the name of an existing
SIP profile.
dial-plan: Specify the name of an existing dial
plan table.
username: The username (from 1 to 25
characters) for VoIP authentication.
password: The password (from 1 to 25
characters) for VOIP authentication.
C13
Table 299 VoIP Configuration Supported on the PMG5318 (continued)
COMMAND DESCRIPTION M P
To Next Page
Loading...
