ZyXEL Communications OLT2406 - Page 597

Chapter 82 DHCP
OLT2406 User’s Guide
597
no dhcp l2agent vlan <vid> ldra
Disables DHCP L2 Agent LDRA function on the
specified VLAN. This has the system forward
DHCPv6 requests for a VLAN without adding
information.
C13
dhcp l2agent opt18-interface-id
vlan <vlan> option-info <info>
Configures the DHCP L2 Agent option 18
interface ID format on the specified VLAN.
Option 18 is required for LDRA. Specify the
Interface ID information to add to the client
DHCPv6 requests forwarded for a VLAN to
identify the interface which received the client
message.
See Table 311 on page 596 for more information
about the
<info> string.
Note: If the string is composed of more
than 127 characters, the string will be
truncated to the maximum number
of characters allowed when the OLT
transforms the string into the
Interface ID.
C13
no dhcp l2agent opt18-interface-id
vlan <vlan>
Disables the DHCP L2 Agent option 18 interface
ID on the specified VLAN.
C13
dhcp l2agent opt37-remote-id vlan
<vlan> option-info <info>
Configures the DHCP L2 Agent option 37
Remote ID format on the specified VLAN.
The required option 37 can only add up to 95
characters of information about the DHCPv6
requests forwarded for this VLAN. Use option 37 if
you need to add extra information beyond
what you configure for option 37.
Option 37 (Remote ID Info) is the DHCPv6
equivalent for the Dynamic Host Configuration
Protocol for IPv4 (DHCPv4) Relay Agent Option's
Remote-ID sub-option.
See Table 311 on page 596 for more information
about the
<info> string.
Note: If the string is composed of more
than 95 characters, the string will be
truncated to the maximum number
of characters allowed when the OLT
transforms the string into the Remote
ID.
C13
no dhcp l2agent opt37-remote-id
vlan <vlan>
Disables the DHCP L2 Agent option 37 Remote
ID on the specified VLAN.
C13
Table 312 DHCP L2 Agent Commands (continued)
COMMAND DESCRIPTION M P