ZyXEL Communications OLT2406 - Page 654

Chapter 95 CFM Commands
OLT2406 User’s Guide
654
mhf-creation < none | default |
explicit>
Sets MHF (MIP Half Function).
Select none and no MIP can be created
automatically for this MA.
Select default to automatically create MIPs for
this MA and on the ports belonging to this MA’s
VLAN when there are no lower configured MD
levels or there is an MEP at the next lower
configured MD level on the port.
Select explicit to automatically create MIPs
for this MA and on the ports belonging to this
MA’s VLAN only when there is an MEP at the
next lower configured MD level on the port.
C13
remote-mep <1-8091>
Sets a remote MEP in an MA. C 13
remote-mep <1-8091> mac <mac-
address>
Sets a remote MEP with a specified MAC
address.
C13
no mep <1-8091>
Deletes a specified MEP. C 13
no mep <1-8091> cc-enable
Disallows an MEP sending Connectivity Check
Messages (CCMs) periodically to other MEPs.
C13
no mep <1-8091> inactive
Enables an MEP. C 13
ethernet cfm management-address-
domain ip
Configures the management IP address as the
CFM management IP address.
C13
ethernet cfm management-address-
domain ip <ip-addr>
Sets the OLT to carry the host name and
management IP address for the VLAN to which
an MEP belongs or the specified IP address in
CFM packets.
This helps you to easily identify a remote MEP by
its host name and management IP address
showed in the link trace database and MEP-
CCM database.
C13
interface port-channel <aid>
Enters config-interface mode for configuring the
specified port(s).
<
aid>: <ge|msc|pon>-<slot>-<port>
C13
ethernet cfm virtual-mac <mac-
addr>
Assigns a virtual MAC address(es) to the
specified port(s) so that each specified port can
have its own MAC address for CFM.
You cannot use the copy running-config
interface port-channel command to copy
the virtual MAC address from the specified port
to other ports.
C13
exit
Exits from the command. C 13
show ethernet cfm linktrace
Displays the CFM link trace database
information.
E13
show ethernet cfm local
Displays the detailed settings of the configured
MD(s) and MA(s).
E13
show ethernet cfm virtual-mac
Displays all virtual MAC addresses. E 13
show ethernet cfm virtual-mac port
<aid>
Displays the MAC address(es) of the specified
port(s).
E13
Table 351 CFM Commands (continued)
COMMAND DESCRIPTION M P