Chapter 4 The Web Configurator
OLT2406 User’s Guide
67
Static Multicast
Forwarding
This link takes you to a screen where you can configure static multicast MAC addresses for
port(s). These static multicast MAC addresses do not age out.
MAC Forced
Forwarding
This link takes you to a screen where you can manage MAC forced forwarding profiles. These
profiles configure a static forwarding table that lets you forward enabled VLANs’ traffic to
specific access routers or servers.
Filtering This link takes you to a screen to set up filtering rules.
Spanning Tree
Protocol
This link takes you to screens where you can configure the RSTP/MRSTP/MSTP to prevent
network loops.
Bandwidth
Control
This link takes you to a screen where you can configure bandwidth limits on the OLT.
Broadcast Storm
Control
This link takes you to a screen to set up broadcast filters.
Mirroring This link takes you to screens where you can copy traffic from one port or ports to another port
in order that you can examine the traffic from the first port without interference.
Link Aggregation This link takes you to screens where you can logically aggregate physical links to form one
logical, higher-bandwidth link.
Port
Authentication
This link takes you to a screen where you can configure IEEE 802.1x port authentication as well
as MAC authentication for clients communicating via the OLT.
Port Security This link takes you to screens where you can activate MAC address learning and set the
maximum number of MAC addresses to learn on a port.
Classifier This link takes you to screens where you can configure the OLT to group packets based on the
specified criteria.
Policy Rule This link takes you to a screen where you can configure the OLT to perform special treatment
on the grouped packets.
Queuing Method This link takes you to a screen where you can configure queuing with associated queue
weights for each port.
VLAN Stacking This link takes you to screens where you can activate and configure VLAN stacking.
Multicast This link takes you to screens where you can configure various multicast features, IGMP
snooping, MLD snooping-proxy and create multicast VLANs.
AAA This link takes you to a screen where you can configure authentication, authorization and
accounting services via external servers. The external servers can be either RADIUS (Remote
Authentication Dial-In User Service) or TACACS+ (Terminal Access Controller Access-Control
System Plus).
IP Source Guard This link takes you to screens where you can configure filtering of unauthorized DHCP and ARP
packets in your network.
Loop Guard This link takes you to a screen where you can configure protection against network loops that
occur on the edge of your network.
PPPoE This link takes you to screens where you can configure intermediate agent settings in port,
VLAN, and PPPoE.
Errdisable This link takes you to screens where you can view errdisable status and configure errdisable
settings in CPU protection, errdisable detect, and errdisable recovery.
ONT VoIP This link takes you to screens where you can configure VoIP settings for the subscriber Optical
Network Terminal (ONT) devices.
PON DDMI This link takes you to screens where you can configure profiles of ONT alarm thresholds. You can
also configure high and low parameter limits for your OLT’s SFP transceivers in this screen.
File Transfer This link takes you to a screen where you can transfer a config.xml file between a specific URL
and an ONT using FTP.
Ont PM Counter This link takes you to a screen where you can view the performance monitoring counters for the
specified subscriber Ethernet interface.
Table 13 Navigation Panel Links (continued)
LINK DESCRIPTION
To Next Page
Loading...
