Chapter 98 Port Protection Switching
OLT2406 User’s Guide
693
Figure 292 Downlink Port Protection Switching
The following section lists the commands for this feature.
Table 367 Downlink Port Protection Switching Commands
COMMAND DESCRIPTION M P
show protect-switch pon status
Displays the current status of the downlink PON
port protection switching operation.
E 3
switch-over pon <aid>
Triggers a PON port protection switch-over
operation.
aid: pon-<slot>-<pon>
E 13
protect-switch pon pon-<slot>-
<port> pon-<slot>-<port>
Assigns the specified downlink PON ports as an
active and backup pair. You can configure
multiple pairs of PON ports, but each PON port
can only be in one pair at a time.
pon pon-<slot>-<port> is the active port, and
pon-<slot>-<port> is the standby port.
C13
Working path
Backup path
Traffic from
uplink
To Next Page
Loading...
