Chapter 102 PPPoE IA
OLT2406 User’s Guide
707
test pppoe-client start <aid>
username <username> password
<password> vlan <snisvid> [snicvid
<1-4094>] [ nnisvid <1-4094> ] [
univid <1-4094> ] [ ontid <1-128> ]
[ ontcardid <1-16> ] [ uniport <1-
128> ] [ ontsn <16 hex numbers> ] [
timeout <10-300> ]
Starts a PPPoE client test to simulate the ONT
creating a PPPoE session and getting an IP
address from the PPPoE server. Up to 1 session
can be simulated at a time.
aid: <ge|pon>-<slot>-<port>
username: the user name of the PPPoE account,
length 1-32
password: the password of the PPPoE account,
length 1-32
snisvid: Choose SNI SVID on subscriber port
(ONT), 1-4094. This is the outer VLAN on the
service node interface.
snicvid: SNI CVID setting on subscriber port
(ONT), 1-4094. If not set and PPPoE IA needs this
value, it will show 4096. This is the inner VLAN on
the service node interface.
nnisvid: NNI SVID setting on subscriber port
(ONT), 1-4094. If not set and PPPoE IA needs this
value, it will show 4096. This is the outer VLAN on
the network to network interface.
univid: UNI VID setting on subscriber port (ONT),
1-4094. If not set and PPPoE IA needs this value, it
will show 4096. This is the (outer) VLAN on the
user node interface.
ontid: ONT ID to be added to the PPPoE IA
information, 1-128
ontcardid: ONTCARD ID to be added to the
PPPoE IA information, 1-16
uniport: UNIPORT value to be added to the
PPPoE IA information, 1-128
ontsn: ONT serial number to be added to the
PPPoE IA information, 16 HEX characters long
timeout: timeout value for the simulation. 10-
300 seconds, default value: 30 seconds
E13
test pppoe-client start help
Provides more information about the specified
command.
E13
test pppoe-client status
Displays the PPPoE client simulation results. E 13
test pppoe-client stop
Stops the PPPoE client test. E 13
Table 371 PPPoE Intermediate Agent Commands (continued)
COMMAND DESCRIPTION M P
To Next Page
Loading...
