ZyXEL Communications OLT2406 - Page 712

Chapter 103 Port Bridge
OLT2406 User’s Guide
712
interface port-channel <aid>
Enters config-interface mode for the specified
port(s).
aid: <ge|msc|pon>-<slot>-<port>
C13
port-bridge active <cr>
Enables the per-port-per-VLAN port bridge
feature on the specified port.
C13
no port-bridge active <cr>
Disables the per-port-per-VLAN port bridge
feature on the specified port.
C13
port-bridge mode <l2|ip> vlan-
list <vlist> [ip-subnet <ip>
<netmask>]
Configures the port bridge mode (l2 & ip) and
the VLAN group(s) for the per-port-per-VLAN
port bridge feature on the specified port.
mode <l2|ip>: Selects l2 to pass all kinds of
packets; selects ip to pass only IPv4 and ARP
packets.
[ip-subnet <ip> <netmask>]: Sets the IP
address and subnet mask of the ONT that the
port bridge mode settings will be applied to.
C13
no port-bridge mode <cr>
Removes the port bridge settings on the
specified port.
C13
show port-bridge <aid>
Displays if the per-port-per-VLAN port bridge
feature is enabled on the specified port or not.
aid: <ge|msc|pon>-<slot>-<port>
E3
show interfaces config <aid> port-
bridge <cr>
Displays the configuration information of per-
port-per-VLAN port bridge feature for the
specified port.
aid: slot-<slot> | <ge|msc|pon>-<slot>-
<port>
E13
Table 373 Port Bridge Commands (continued)
COMMAND DESCRIPTION M P