Chapter 109 Troubleshooting
OLT2406 User’s Guide
739
system Linecard Restore config timeout SYSTEM INFO
system Linecard Unplugged SYSTEM INFO
system Load factory default configuration failed SYSTEM ERR
system Load factory default configuration successfully SYSTEM INFO
system pon/ge card restore config failed SYSTEM INFO
system pon/ge card restore config failed in 12 seconds SYSTEM INFO
system pon/ge card Restore config ready SYSTEM INFO
system Poncard Binding time out SYSTEM WARNING
system Poncard Downloading SYSTEM INFO
system Poncard Downloading and binding Fail SYSTEM WARNING
system Poncard embedded image launch fail SYSTEM INFO
system Poncard pon bind continue fail SYSTEM INFO
system Poncard pon bind success SYSTEM INFO
system Poncard Ready SYSTEM INFO
system Poncard Ready to restore cfg SYSTEM INFO
system Port is detected a errdisable port by inactive-port SYSTEM INFO
system Port is recovered by errdisable recovery SYSTEM INFO
system Port intrusion lock SYSTEM NOTICE
system Port is detected a errdisable port SYSTEM INFO
system Port loopguard SYSTEM NOTICE
system Restore system configuration failed SYSTEM ERR
system Restore system configuration successfully SYSTEM INFO
system RPM value is out of its limit range SYSTEM CRITICAL
system Save system configuration failed SYSTEM INFO
system Save system configuration successfully SYSTEM INFO
system System cold start SYSTEM NOTICE
system System has reset due to a management command / controlled
reset
SYSTEM NOTICE
system System has reset without management command / uncontrolled
reset
SYSTEM ALERT
system System reboot SYSTEM NOTICE
system System reboot by user SYSTEM NOTICE
system System temperature has recovered to normal state SYSTEM EMERGEMCY
system System voltage has recovered to normal state SYSTEM CRITICAL
system System warm start SYSTEM NOTICE
system Temperature value is out of its limit range SYSTEM EMERGEMCY
system The RPM of the fan has recovered to normal state SYSTEM CRITICAL
system Upgrade system firmware failed SYSTEM ERR
system Upgrade system firmware successfully SYSTEM INFO
system voltage value is out of its limit range SYSTEM CRITICAL
Table 385 Log Messages (continued)
Category Log Message Type Severity
To Next Page
Loading...
