Chapter 5 Initial Setup Example
OLT2406 User’s Guide
75
Figure 43 Initial Setup Example: Management IP Address
1 Connect your computer to any Ethernet port on the OLT. Make sure your computer is in the same subnet
as the OLT.
2 Open your web browser and enter 192.168.1.1 (the default in-band IP address) in the address bar to
access the web configurator. See Section 4.2 on page 64 for more information.
3 Click Basic Setting > IP Setup in the navigation
panel.
4 Configure the related fields in the IP Setup screen.
5 For the VLAN2 network, enter 192.168.2.1 as the IP
address and 255.255.255.0 as the subnet mask.
6 In the VID field, enter the ID of the VLAN group to
which you want this management IP address to
belong. This is the same as the VLAN ID you
configure in the Static VLAN screen.
7 Click Add to save your changes back to the run-
time memory. Settings in the run-time memory are
lost when the OLT’s power is turned off.
To Next Page
Loading...
