Anritsu MS9740A - Calculate:data:apr:wtbl

3.4 Device Message Details
3-65
3
Message Details
:CALCulate:DATA:APR:WTBL?
Function
This command queries the analysis results at the Table display of the
WDM application function for the specified peak No.
Syntax
:CALCulate:DATA:APR:WTBL? <numeric>
<numeric>: No. of peak to query analysis results
Response Data
<numeric>,<numeric>,<numeric>,<numeric>,<numeric>,<numer
ic>,<numeric>
No.
Parameter type
Description
1
<numeric>
Specified peak No. peak wavelength (m)
2
<numeric>
Specified peak No. peak frequency (Hz)
3
<numeric>
Peak level of specified peak (dBm)
4
<numeric>
Signal to noise ratio of specified peak (dB)
5
<switch>=
AVERAGE|
LEFT|RIGHT|
ERR|FITTING
Specified peak No. noise detection method
ERR when noise position off screen at noise
detection
FITTING when Noise Parameter Detection
Type is Area
6
<numeric>
Specified peak No. peak wavelength spacing
(m)
7
<numeric>
Specified peak No. peak frequency spacing
(Hz)
Example of Use
:CALCulate:DATA:APR:WTBL? 1
>+1.55276000E-006,+1.93070700e+014,-1.90200000E+000,+5.1
4000000E+001,RIGHT,0,0