Anritsu MS9740A - Calculate:data:apr:amtbl

Chapter 3 Message Details
3-56
:CALCulate:DATA:APR:AMTBl?
Function
This command queries the results analyzed by the Optical AMP (WDM)
application, specifying the peak No.
Syntax
:CALCulate:DATA:APR:AMTBl? <numeric>
<numeric>: Peak No. to query the analysis results
Response Data
<numeric>,<numeric>,<numeric>,<numeric>,<numeric>,<numer
ic>,<numeric>
No.
Parameter type
Description
1
<numeric>
Wl: Peak wavelength of specified peak
No. (m)
2
<numeric>
Pin: Optical input level (dBm) for the
specified peak No.
3
<numeric>
Pout: Optical output level (dBm) for the
specified peak No.
4
<numeric>
ASE: Amplified spontaneous emission
level (dBm) for the specified peak No.
5
<numeric>
Res: Actual resolution (m) for the
specified peak No.
6
<numeric>
Gain: Gain (dB) for the specified peak
No.
7
<numeric>
NF: Noise Figure (dB) for the specified
peak No.
Example of Use
:CALCulate:DATA:APR:AMTBl? 1
>+1.54681500E-006,-3.40600000E+001,-8.72000000E+000,-2.5
2900000E+001,8.90000000E-011,+2.58800000E001,+7.26000000
E+000