Anritsu MS9740A - Calibration:actres:data; Calibration:alig[:Immediate]

Chapter 3 Message Details
3-184
:CALibration:ACTRes:DATA?
Function
This command queries the actual resolution.
Syntax
:CALibration:ACTRes:DATA?
Response Data
<numeric>
<numeric>: Actual resolution (m)
Example of Use
:CALibration:ACTRes:DATA?
>+2.05000000E-010
:CALibration:ALIG[:IMMediate]
Function
This command
executes optical alignment. When alignment is complete, bit
4 of the end event status register (execution complete bit) is set to 1.
Syntax
:CALibration:ALIG[:IMMediate]
:CALibration:ALIG[:IMMediate]?
Response Data
0|1|2|3
0: Normal end
1: During alignment
2: Aborted optical alignment due to lack of optical level
3: Aborted optical alignment due to other abnormality
Example of Use
:CALibration:ALIG:IMMediate
:CALibration:ALIG:IMMediate?
>0