Anritsu MS9740A - Chapter 3 Message Details

3-1
3
Message Details
Chapter 3
Message Details
This chapter describes the message details of remote control commands
for MS9740A.
For the initial value of parameters, refer to Appendix B, “Initial Values”
in the
MS9740A Optical Spectrum Analyzer Operation Manual .
3.1
Rules for Describing Messages .................................... 3-2
3.2 Correspondence between Panel Operation and
Message ....................................................................... 3-3
3.2.1 Panel key .......................................................... 3-3
3.2.2 Function key ..................................................... 3-5
3.3 Message Function Category ....................................... 3-22
3.3.1 IEEE488.2 Common Messages and Device
Dependent Messages..................................... 3-22
3.3.2 System Management and Measurement
Commands ..................................................... 3-23
3.4 Device Message Details ............................................. 3-26
3.4.1 IEEE488.2 Common Message ....................... 3-26
3.4.2 ABORt Subsystem .......................................... 3-32
3.4.3 CALCulate Subsystem ................................... 3-32
3.4.4 CALibration Subsystem ................................ 3-183
3.4.5 DISPlay Subsystem ...................................... 3-192
3.4.6 FORMat Subsystem ..................................... 3-206
3.4.7 INITiate Subsystem ...................................... 3-208
3.4.8 INSTrument Subsystem ............................... 3-212
3.4.9 MMEMory Subsystem .................................. 3-213
3.4.10 SENSe Subsystem ....................................... 3-233
3.4.11 SOURce Subsystem ..................................... 3-246
3.4.12 STATus Subsystem ...................................... 3-247
3.4.13 SYSTem Subsystem .................................... 3-249
3.4.14 TRACe Subsystem ....................................... 3-252
3.4.15 TRIGger Subsystem ..................................... 3-263
3.4.16 UNIT Subsystem .......................................... 3-265