Anritsu MS9740A - Trace:points; Trace:state[:<Trace_Name>|Trg]

3.4 Device Message Details
3-261
3
Message Details
:TRACe:POINts
Function
This command sets and queries the number of sampling points.
Syntax
:TRACe:POINts TRA|TRB|TRC|TRD|TRE|TRF,<numeric>
:TRACe:POINts?
Specify any of the following to <numeric>.
51, 101, 251, 501, 1001, 2001, 5001, 10001, 20001, 50001
Response Data
51|101|251|501|1001|2001|5001|10001|20001|50001
Example of Use
:TRACe:POINts TRF,2001
:TRACe:POINts?
>2001
:TRACe:STATe[:<trace_name>|TRG]
Function
This command sets and queries the trace display.
Syntax
:TRACe:STATe[:<trace_name>|TRG] 0|1|OFF|ON
:TRACe:STATe[:<trace_name>|TRG]?
0|OFF: Does not display the trace.
1|ON: Displays the trace.
Response Data
0|1
Example of Use
:TRACe:STATe:B ON
:TRACe:STATe:B?
>1