Anritsu MS9740A - Calculate:parameter[:Category]:Wdm:area; Calculate:parameter[:Category]:Wdm:dtype

Chapter 3 Message Details
3-152
:CALCulate:PARameter[:CATegory]:WDM:AREA
Function
This command sets the Area Type in Noise Parameter for the WDM
application to Channel or User Specify and queries the Area Type.
Syntax
:CALCulate:PARameter[:CATegory]:WDM:AREA [CH|USER]
:CALCulate:PARameter[:CATegory]:WDM:AREA?
CH: Sets Area Type to Channel
USER: Sets Area Type to User Specify
When the parameter is omitted, the Noise Parameter Detection Type is
set to Area.
Response Data
CH|USER
Example of Use
:CALCulate:PARameter:CATegory:WDM:AREA USER
:CALCulate:PARameter:CATegory:WDM:AREA?
>USER
:CALCulate:PARameter[:CATegory]:WDM:DTYPe
Function
This command sets and queries the display method for the WDM
application.
Syntax
:CALCulate:PARameter[:CATegory]:WDM:DTYPe
<switch>[,<numeric>]
:CALCulate:PARameter[:CATegory]:WDM:DTYPe? [REL]
<switch>
Screen display
ABSolute
Table
RELative
Relative
MPK
Multi Peak
TBL
Table
SNR
SNR
When <switch> is set to REL, <numeric> can be specified.
<numeric>: Reference wavelength number from 1 to 300