Anritsu MS9740A - Calculate:parameter[:Category]:Ld:sglevel

Chapter 3 Message Details
3-122
:CALCulate:PARameter[:CATegory]:LD:SGLevel
Function
This command sets and queries the level detection method in Signal
Parameter for LD Module application.
Syntax
:CALCulate:PARameter[:CATegory]:LD:SGLevel
{INTG[,<numeric>[<unit_m>]]|POINT}
:CALCulate:PARameter[:CATegory]:LD:SGLevel?
Parameter 1: Sets Detection Type
INTG: ΣPower
POINT: Point
Parameter 2:
<numeric>: Signal Span (m)
Range 0.01 to 50.00 nm
Resolution 0.01 nm
If a suffix is omitted, the unit will be m.
If Parameter 2 is omitted, the Signal Span value is not changed.
Response Data
INTG|POINT,<numeric>
<numeric>: Signal Span (m)
+1.00000000E–011 to +5.00000000E–008
Example of Use
:CALCulate:PARameter:CATegory:LD:SGLevel INTG,0.5NM
:CALCulate:PARameter:CATegory:LD:SGLevel?
>INTG,+5.00000000E-010