Anritsu MS9740A - Calculate:parameter[:Category]:Ld:sgselect

3.4 Device Message Details
3-123
3
Message Details
:CALCulate:PARameter[:CATegory]:LD:SGSelect
Function
This command sets and queries the signal level in Signal Parameter for
the LD Module application.
Syntax
:CALCulate:PARameter[:CATegory]:LD:SGSelect SIGNOI|SIG
:CALCulate:PARameter[:CATegory]:LD:SGSelect?
SIGNOI: Signal - Noise
SIG: Signal
Response Data
SIGNOI|SIG
Example of Use
:CALCulate:PARameter:CATegory:LD:SGSelect SIGNOI
:CALCulate:PARameter:CATegory:LD:SGSelect?
>SIGNOI