Anritsu MS9740A - Calculate:parameter[:Category]:Wfil:sglevel

Chapter 3 Message Details
3-172
:CALCulate:PARameter[:CATegory]:WFIL:SGLevel
Function
This command sets and queries the channel level detection method at
WDM filter application.
Syntax
:CALCulate:PARameter[:CATegory]:WFIL:SGLevel
INTG|POINT[,<numeric>[<unit_m>]]
:CALCulate:PARameter[:CATegory]:WFIL:SGLevel?
Parameter 1: Sets Detection Type
INTG: ΣPower
POINT: Point
Parameter 2:
<numeric>: Signal Span
Range 0.01 to 50.00 nm
Resolution 0.01 nm
If a suffix is omitted, the unit will be m.
If Parameter 2 is omitted, Signal Span is not changed.
Response Data
{INTG,<numeric>}|POINT
<numeric> Signal Span (m)
+1.00000000E–011 to +5.00000000E–008
Example of Use
:CALCulate:PARameter:CATegory:WFIL:SGLevel INTG,0.5NM
:CALCulate:PARameter:CATegory:WFIL:SGLevel?
>INTG,+5.00000000E-010