Anritsu MS9740A - Calculate:parameter[:Category]:Nf:obpf

3.4 Device Message Details
3-137
3
Message Details
:CALCulate:PARameter:CATegory:NF:MSELect?
>PIN
:CALCulate:PARameter[:CATegory]:NF:OBPF
Function
This command sets the O.BPF Lvl Cal/BW for the Optical AMP (WDM)
application.
This command queries the O.BPF Lvl Cal/BW setting for the Optical
AMP (WDM) application.
Syntax
:CALCulate:PARameter[:CATegory]:NF:OBPF
<numeric>,<numeric>[<unit_m>]
:CALCulate:PARameter[:CATegory]:NF:OBPF?
No.
Parameter type
Range
Description
1
<numeric>
0.00 to 30.00 dB
Res. 0.01 dB
O.BPF Level Calibration
Optical filter loss
correction coefficient
If a suffix is omitted, the
unit will be dB.
2
<numeric>
0.00 to 999.99 nm
Res. 0.01 nm
O.BPF Band Width
Optical filter pass band
width
If a suffix is omitted, the
unit will be m.
Response Data
<numeric>,<numeric>
No.
Parameter type
Description
1
<numeric>
O.BPF Level Calibration (dB)
Optical filter loss correction coefficient
2
<numeric>
O.BPF Band Width (m)
Optical filter pass band width
Example of Use
:CALCulate:PARameter:CATegory:NF:OBPF 1.00dB,30.00nm
:CALCulate:PARameter:CATegory:NF:OBPF?
>+1.00000000E+000,+3.00000000E-008