Anritsu MS9740A - Calculate:parameter[:Category]:Wdm:nafunction

3.4 Device Message Details
3-157
3
Message Details
:CALCulate:PARameter[:CATegory]:WDM:NAFunction
Function
This command sets and queries the Fitting Curve in Noise Parameter for
the WDM application.
Syntax
:CALCulate:PARameter[:CATegory]:WDM:NAFunction
<switch>,0|1|OFF|ON
:CALCulate:PARameter[:CATegory]:WDM:NAFunction?
Parameter 1: Fitting Curve Type
<switch>
Fitting Curve
LINear
Linear
GAUSs
Gauss
3RD
3rd POLY
4TH
4th POLY
5TH
5th POLY
Parameter 2: Fitting Curve Display
0|OFF: Does not display fitting curve
1|ON: Displays fitting curve
Response Data
<switch>,0|1
Example of Use
:CALCulate:PARameter:CATegory:WDM:NAFunction LINear,ON
:CALCulate:PARameter:CATegory:WDM:NAFunction?
>LINEAR,1