Anritsu MS9740A - Instrument:select

Chapter 3 Message Details
3-212
3.4.8 INSTrument Subsystem
:INSTrument:SELect
Function
This command sets the type of application function and performs
analysis.
When the processing is completed, bit 0 (measurement end bit) of the end
event status register is set to 1.
This command terminates the display of the application function.
This command queries the application function that is running.
Syntax
:INSTrument:SELect <switch>
:INSTrument:SELect?
<switch>: Specify an application from the following.
<switch>
Application Type
'AMP'
Optical amplifier
'AMP2'
Optical amplifier (WDM)
'Amp_ISS_Test'
Optical amplifier (WDM)
'DFB'
Distributed feedback laser diode
'FP'
Fabry-Perot laser diode
'LD'
Laser diode module
'LED'
Light-emitting diode
'OFF'
End of application function
'OSA'
End of application function
'PMD'
Polarization mode dispersion
'WDM'
Wavelength division multiplexing
'WDM_AutoScan'
Wavelength division multiplexing
'WFIL'
WDM filter
Example of Use
:INSTrument:SELect 'WDM_Autoscan'
:INSTrument:SELect?
>WDM_AutoScan