Chapter 2 Before Use
2-14
2.3.2 Setting GPIB
Check the MS9740A GPIB address and delimiter with the following
procedure.
1. Press
F6
to display Config on the horizontal function keys.
2. Press
f 1 Interface Setting
.
3. Open the dialog box. The MS9740A address is displayed in the GPIB
setting address.
4. Set the GPIB address in the range from 1 to 30 using the arrow keys
or rotary knob.
5. Set the terminator of the response message.
Select “CR/LF,” “LF,” or “None (EOI only)” for Terminator in the
Terminator Settings field.
To Next Page
Loading...
