Anritsu MS9740A - Display[:Window[1]]:Trace:all[:Scale][:Auto]; Display[:Window[1]]:Trace[:State]

Chapter 3 Message Details
3-196
:DISPlay[:WINDow[1]]:TRACe:ALL[:SCALe][:AUTO]
Function
This command performs the measurement automatically.
Bit 0 of the end event status register is set to 1 when measurement ends.
This command queries the automatic measurement status.
Syntax
:DISPlay[:WINDow[1]]:TRACe:ALL[:SCALe][:AUTO]
:DISPlay[:WINDow[1]]:TRACe:ALL[:SCALe][:AUTO]?
Response Data
0|1
0:
Measurement end (Both successful end and failed end)
1:
Measurement in progress
Example of Use
:DISPlay:WINDow1:TRACe:ALL
:DISPlay:WINDow1:TRACe:ALL?
>1
:DISPlay:WINDow1:TRACe:ALL?
>0
:DISPlay[:WINDow[1]]:TRACe[:STATe]
Function
This command sets and queries the trace display.
Syntax
:DISPlay[:WINDow[1]]:TRACe[:STATe] <switch>,0|1|OFF|ON
:DISPlay[:WINDow[1]]:TRACe[:STATe]? <switch>
<switch>: Specify a trace from the following.
A|B|C|D|E|F|G|H|I|J|TRA|TRB|TRC|TRD|TRE|TRF
0|OFF: Deletes the specified trace waveform.
1|ON: Displays the specified trace waveform.
Response Data
0|1
Example of Use
:DISPlay:WINDow:TRACe:STATe I,ON
:DISPlay:WINDow:TRACe:STATe? I