Anritsu MS9740A - Calculate:parameter[:Category]:Nf:farea; Calculate:parameter[:Category]:Nf:ioffset

Chapter 3 Message Details
3-134
:CALCulate:PARameter[:CATegory]:NF:FARea
Function
This command sets and queries the Fitting Span for the Optical AMP
(WDM) application.
Syntax
:CALCulate:PARameter[:CATegory]:NF:FARea
<numeric>[<unit_m>]
:CALCulate:PARameter[:CATegory]:NF:FARea?
Range 0.10 to 100.00 nm
Resolution 0.01 nm
If a suffix is omitted, the unit will be m.
Response Data
<numeric>
<numeric>: Fitting Span (m)
+1.00000000E
–
010 to +1.00000000E–007
Example of Use
:CALCulate:PARameter:CATegory:NF:FARea 5NM
:CALCulate:PARameter:CATegory:NF:FARea?
>+5.00000000E-009
:CALCulate:PARameter[:CATegory]:NF:IOFFset
Function
This command sets and queries the Loss correction factor for signal level
of the Optical AMP (WDM) application.
Syntax
:CALCulate:PARameter[:CATegory]:NF:IOFFset <numeric>[DB]
:CALCulate:PARameter[:CATegory]:NF:IOFFset?
<numeric>: Pin Loss (Offset)
Range –10.00 to 10.00 dB
Resolution 0.01 dB
If a suffix is omitted, the unit will be dB.
Response Data
<numeric>