Anritsu MS9740A - Calculate[1|2|3|4|5|6]:Source:test

Chapter 3 Message Details
3-180
:CALCulate[1|2|3|4|5|6]:SOURce:TEST
Function
This command runs the DFB application, FP-LD application or LED
application.
This command queries which application is running.
When the analysis has completed, the bit 0 (measurement-end bit) of the
end event status register is set to 1.
Syntax
:CALCulate[1|2|3|4|5|6]:SOURce:TEST DFB|FP|LED|OFF
:CALCulate[1|2|3|4|5|6]:SOURce:TEST?
Specify the Active trace (A to F) by specifying a number from 1 to 6.
When omitted, the Active trace is not changed.
DFB: Runs the DFB application.
FP: Runs the FP-LD application.
LED: Runs the LED application.
OFF: Sets the analysis by application to Off.
Response Data
DFB|FP|LED|OFF