Anritsu MS9740A - Calculate:parameter[:Category]:Nf:snoise

3.4 Device Message Details
3-143
3
Message Details
:CALCulate:PARameter[:CATegory]:NF:SNOise
Function
This command sets and queries the NF calculation method for the
Optical AMP (WDM) application.
Syntax
:CALCulate:PARameter[:CATegory]:NF:SNOise 0|1|OFF|ON
:CALCulate:PARameter[:CATegory]:NF:SNOise?
0|OFF: Sets NF Select to S-ASE
1|ON: Sets NF Select to Total
Response Data
0|1
Example of Use
:CALCulate:PARameter:NF:SNOise OFF
:CALCulate:PARameter:NF:SNOise?
>0