Anritsu MS9740A - Calculate:category

3.4 Device Message Details
3-39
3
Message Details
:CALCulate:CATegory
Function
This command sets the type of analysis function or application and
performs analysis.
This command queries the type of analysis function or application
executed last.
When the analysis has completed, the bit 0 (measurement-end bit) of the
end event status register is set to 1.
Syntax
:CALCulate:CATegory <switch>
:CALCulate:CATegory?
<switch>
Description
0|SWTHresh
Executes the Threshold method analysis.
1|SWENvelope
Executes the Envelope method analysis.
3|SWPKrms
Executes the RMS method analysis
5|DFBLd
Executes the Distributed feedback laser diode
application
6|FPLD
Executes the Fabry-Perot laser diode application
7|LED
Executes the Light-emitting diode application
9|POWer
Executes the Spectrum analysis for integral power.
11|WDM
Executes the wavelength division multiplex
application.
12|NF
Executes the Optical amplifier (WDM) application.
15|WFPeak
Executes the WDM filter application.
20|NDB
Executes the ndB-Loss method analysis.
21|SMSR
Executes the SMSR method analysis.
22|AMP
Executes the Optical amplifier application.
23|LD
Executes the Laser diode module application.
24|PMD
Executes the Polarization mode dispersion
application
OFF
Terminates the display of analysis results or
application function.
In the response data, it means that the analysis is
not executed.
Response Data
<switch>
The switch values in the response data are shown below:
0|1|3|5|6|7|9|11|12|15|20|21|22|23|24|OFF