Anritsu MS9740A - Calculate:parameter[:Category]:Nf:pdisplay; Calculate:parameter[:Category]:Nf:pin

3.4 Device Message Details
3-141
3
Message Details
:CALCulate:PARameter[:CATegory]:NF:PDISplay
Function
This command sets and queries the On/Off state of the Fitting Curve
display of the Optical AMP (WDM) application.
Syntax
:CALCulate:PARameter[:CATegory]:NF:PDISplay 0|1|OFF|ON
:CALCulate:PARameter[:CATegory]:NF:PDISplay?
0|OFF: Fitting curve not displayed
1|ON: Fitting curve displayed
Response Data
0|1
Example of Use
:CALCulate:PARameter:CATegory:NF:PDISplay ON
:CALCulate:PARameter:CATegory:NF:PDISplay?
>1
:CALCulate:PARameter[:CATegory]:NF:PIN
Function
This command selects the trace memory for saving the Pin of the Optical
AMP (WDM) application.
This command queries the trace memory for saving the Pin of the Optical
AMP (WDM) application.
Syntax
:CALCulate:PARameter[:CATegory]:NF:PIN <trace>
:CALCulate:PARameter[:CATegory]:NF:PIN?
Response Data
<trace>
Example of Use
:CALCulate:PARameter:CATegory:NF:PIN G
:CALCulate:PARameter:CATegory:NF:PIn?
>G