Anritsu MS9740A - Calculate:math:trx:normalize; Calculate[1|2|3|4|5|6]:Maximum[:State]

Chapter 3 Message Details
3-100
:CALCulate:MATH:TRX:NORMalize
Function
This command sets and queries the level display to the absolute or
relative values.
Syntax
:CALCulate:MATH:TRX:NORMalize NRM|NRMZ
:CALCulate:MATH:TRX:NORMalize?
NRM: Absolute value display (Normal)
NRMZ: Relative value display (Normalize)
Response Data
NRM|NRMZ
Example of Use
:CALCulate:MATH:TRX:NORMalize NRM
:CALCulate:MATH:TRX:NORMalize?
>NRM
:CALCulate[1|2|3|4|5|6]:MAXimum[:STATe]
Function
This command sets and queries the On/Off state of the Max Hold
function for Storage Mode.
Syntax
:CALCulate[1|2|3|4|5|6]:MAXimum[:STATe] 0|1|OFF|ON
:CALCulate[1|2|3|4|5|6]:MAXimum[:STATe]?
Specify the Active trace (A to F) by specifying a number from 1 to 6.
When omitted, the Active trace is not changed.
0|OFF: Turns off the Max Hold function for Storage Mode.
1|ON: Turns on the Max Hold function for Storage Mode.
Response Data
0|1
Example of Use
:CALCulate1:MAXimum:STATe ON
:CALCulate1:MAXimum:STATe?
>1