Anritsu MS9740A - Sense:att:state; Sense:average:count

Chapter 3 Message Details
3-234
:SENSe:ATT[:STATe]
Function
This command sets the internal optical attenuator.
This command queries the internal optical attenuator status.
Syntax
:SENSe:ATT[:STATe] 0|1|OFF|ON
:SENSe:ATT[:STATe]?
0|OFF: Does not use the optical attenuator.
1|ON: Uses the optical attenuator.
Response Data
0|1
Example of Use
:SENSe:ATT:STATe ON
:SENSe:ATT:STATe?
>1
:SENSe:AVERage:COUNt
Function
This command sets and queries the average processing (point averaging)
count.
Syntax
:SENSe:AVERage:COUNt <numeric>|OFF
:SENSe:AVERage:COUNt?
Range 2 to 1000
Resolution 1
Response Data
<numeric>|OFF
<numeric>: Point averaging setting count 2 to 1000
OFF: Point averaging OFF
Example of Use
:SENSe:AVERage:COUNt 200
:SENSe:AVERage:COUNt?
>200