Anritsu MS9740A - Calculate:parameter[:Category]:Wdm:sglevel

Chapter 3 Message Details
3-164
:CALCulate:PARameter[:CATegory]:WDM:SGLevel
Function
This command sets and queries the Level Detection type of Signal
Parameter for the WDM application.
Syntax
:CALCulate:PARameter[:CATegory]:WDM:SGLevel
{INTG[,<numeric>[<unit_m>]]|POINT}
:CALCulate:PARameter[:CATegory]:WDM:SGLevel?
Parameter 1: Detection Type setting
INTG: ΣPower
POINT: Point
Parameter 2:
<numeric>: Signal Span
Range 0.01 to 50.00 nm
Resolution 0.01 nm
If a suffix is omitted, the unit will be m.
If second parameter is omitted, the Signal Span is not changed.
Response Data
INTG|POINT ,<numeric>
<numeric>: Signal Span (m)
+1.00000000E–011 to +5.00000000E–008
Example of Use
:CALCulate:PARameter:CATegory:WDM:SGLevel INTG,0.5NM
:CALCulate:PARameter:CATegory:WDM:SGLevel?
>INTG,+5.00000000E-010