Anritsu MS9740A - Calculate:parameter[:Category]:Nf:ase

Chapter 3 Message Details
3-132
:CALCulate:PARameter[:CATegory]:NF:ASE
Function
This command sets and queries the ASE Noise Detection Type for the
Optical AMP (WDM) application.
Syntax
:CALCulate:PARameter[:CATegory]:NF:ASE AREA|POINT
:CALCulate:PARameter[:CATegory]:NF:ASE?
AREA: The Detection Type is set to Area.
POINT: The Detection Type is set to Point.
Response Data
AREA|POINT
Example of Use
:CALCulate:PARameter:CATegory:NF:ASE AREA
:CALCulate:PARameter:CATegory:NF:ASE?
>AREA